| Accessories |
|
DA-610
Solid State Wireless Sensor
(For DA-600, 603, 604)
 |
Unlimited sensors may be used with the new
wireless series of Drive-Alerts, allowing you to monitor many areas.
The sensor is encased in a durable outdoor metal enclosure. These
sensors run on two standard AA batteries which will last more than a
year under normal usage. These sensors
may be places up to 1000 feet from the Control Panel, and up to
2500 feet when used with the DA-660. The sensors are tamper resistant due to
the fact that if anyone touches or moves one, the alert will be
triggered.
NOTE: the new wireless systems can be
completely battery operated allowing them to be entirely mobile.
|
DA-611
Solid State Wireless Sensor
(For DA-600, 603, 604)
 |
The DA-611 may be used in place of, or in
addition to, the DA-610 sensors. The DA-611 has all of the
features of the DA-610, plus a 50' cable extension which allows
you to bury the sensor in the area you wish to monitor while
hiding the transmitter up to 50' away.
NOTE: the new wireless systems can be
completely battery operated allowing them to be entirely mobile.
|
DA-660
Long Range Antenna
(For DA-600, 603, 604)
 |
The DA-660 antenna boosts the
wireless Drive-Alert range up to 2500' and in many cases up to
3000'! This is a factory installed item and must be ordered at
the time a wireless system is ordered. This antenna works with
the DA-600, DA-603, and DA-604 models. |
DA-655
Pleasant Chime with
Volume Control
(Works with
DA-500, DA-600)
 |
For those cases where a more pleasant tone is desired, instead of the whistle within the control panel of the DA-500 or DA-600, the DA-655 provides a pleasant tone. This unit can be hardwired to the control panel of the DA-500 or DA-600, and emits a chime when a vehicle is detected. There is also a volume control, and this unit can be turned up to a high level.
We also suggest the DA-503 and the DA-603 systems for customers who desire a pleasant chime.
|
DA-051
Solid Sate Sensors with
Direct Burial Cable
 |
Extra sensors
may be used when knowledge of vehicle movement in more than one
area is desired. The PVC-encased sensor comes with 100 feet of direct
burial cable attached. Sensors with additional lengths of cable
are available. The sensor may be placed up to 5,000 feet from the
Electronic Master Control. As many as three sensors may be added
without loss of sensitivity. |
 DA-052
Remote
Whistle |
The same electronic
whistle which is contained inside the DA-500 and DA-600 control box is mounted
on a chrome plate for installation in additional areas such as a
den, kitchen, or bedroom. As many as 10 remote whistles may be installed.
May be used with both the DA-500 and the
DA-600 models. |
 DA-052
Remote Whistle
with Volume
Control |
The same remote
whistle listed above is also available with volume control. |
| DA-054 3M Splice Kit
 |
Mier
tested and approved, this splice kit provides waterproof connection
for splicing the direct burial cable. Mier recommends ALWAYS using
this kit when it is necessary to splice. Longer cable lengths
are also available. |
| DA-055 Chime with Transformer
 |
This accessory is no longer available. It has been replaced by the
DA-655 (see above). This
system emits a pleasant two-note chime whenever a vehicle is detected.
The power transformer and connecting cable are included. Use with
N/O signal, N/O contacts or N/O switch. |
 DA-057 Transmitter |
Connects
to two Drive-Alert control panel terminals and plugs into the same
120-VAC receptacle as the Drive-Alert. It then transmits over the
house’s wiring to Lamp Modules and Remote Chimes. Only one is
needed. May be used with all models, please
call our technical support team for information. |
 DA-058
Remote
Chime |
The chime makes
a pleasant doorbell sound when activated. These chimes may be plugged
into any 120-volt receptacle, allowing for use at several remote
locations. Any number may be used. May be
used with all models, please call our technical support team for
information. |
 DA-059
Wall Switch |
The
wall switch replaces any normal household wall switch, and when it
receives a signal will turn on the lights that switch controls. Usually
installed at a location controlling front door or garage door lights.
Can also be used to turn lights on and off as any switch does.
May be used only with the DA-604 and DA-504
models. |
 DA-060
Lamp Module
|
The Lamp Module
plugs into any household 120 VAC receptacle, and then a lamp is
plugged into it. Whenever a signal is received from the Transmitter
that a vehicle has entered the driveway, the lamp will come on.
May be used only with the DA-604 and DA-504
models. |
 DA-061 Heavy-Duty Appliance Module
|
Appliance module
for use with heavy duty applications. May be
used with all models, please call our technical support team for
information. |
 DA-063
8" Bell |
For outdoor
use, when a louder alarm is desired. May be
used with all models, please call our technical support team for
information. |
 DA-066
Remote Chime Transmitter
(Standard with DA-605,
accessory for DA-500 or DA-600) |
The DA-066 unit is a standard part of the DA-605 Drive-Alert. When
a vehicle is detected the DA-605 receives a signal and triggers
the DA-066 to send a signal to activate DA-068 Plug-in Remote
Chimes and/or DA-070 Battery-powered Portable Chimes. The DA-066
can also be used as a "test" or "call" button to manually trigger
these chimes. As an accessory, the DA-066 (in conjunction with
the DA-068 and/or DA-070) can be used as an add-on to the DA-500
or DA-600 Drive-Alert models. Sometimes a customer who has one of
these systems later decides he/she would rather have remote
plug-in and/or battery-powered chimes as alerts instead of the
piezo whistle that comes standard in the DA-500 and DA-600.
Instead of buying a completely new system, adding these
accessories to the existing DA-500 or DA-600 gives them these
features, plus chime. |
 DA-067
Antenna Stabilizer
(For DA-610 Sensor/ Transmitter)
|
The DA-067 Antenna Stabilizer slips over the top of the antenna on
the DA-610 Drive-Alert Sensor/Transmitter to eliminate the rare
cases of high-wind or animals moving the antenna and causing false
alarms. |
 DA-068
Plug-in Remote Chime
(For DA-605 and as an accessory with the DA-066 on DA-500 or
DA-600)
|
When the DA-605 Drive-Alert detects a vehicle, a signal is sent to
activate DA-068 Plug-in and/or DA-070 Battery-powered chimes. Any
number and combination of these two types of chimes can be used
together with a DA-605 system. These chimes can be located up to
100 feet away from the control panel. These chimes also feature
volume control and a choice of three tones. As an accessory, the
DA-068 (in conjunction with the DA-066) can be used as an add-on
to the DA-500 or DA-600 Drive-Alert models. See notes under DA-066
for details. |
 DA-070
Battery-powered Portable Chime
(For DA-605 and as an accessory with the DA-066 on DA-500 or
DA-600)
|
When the DA-605 Drive-Alert detects a vehicle, a signal is sent to
activate DA-070 Battery-powered and/or DA-068 Plug-in chimes. Any
number and combination of these two types of chimes can be used
together with a DA-605 system. These chimes can be located up to
100 feet away from the control panel. These chimes also feature
volume control and a choice of three tones. As an accessory, the
DA-070 (in conjunction with the DA-066) can be used as an add-on
to the DA-500 or DA-600 Drive-Alert models. See notes under DA-066
for details. |
 DA-505 Timer Control
|
When used in
conjunction with the Drive-Alert, it will turn on 10 amps of lights,
sirens or bells. The unit simply plugs into a 120 VAC outlet and
contains its own receptacle to provide power to lights or alarms.
The alarm or lights can be adjusted to operate from 1 to 45 minutes.
Also available for 12 volt applications. May
be used with all models, please call our technical support team
for information. |
